Modeling the Performance and Frictional Head Losses of the Control Oil Pump at Derna Steam Power Plant
الكلمات المفتاحية:
Control Oil Pump، Hydraulic Efficiency، Mechanical Efficiency، Darcy–Weisbach Equation، Frictional Head Lossesالملخص
The objective of this research is to analyze the power and efficiency of the control oil pump (COP) at the Derna steam power plant, focusing on calculating frictional head losses (Hƒ), volumetric flow rate, and mass flow rate within the pipeline system. The evaluation is based on a computational model and empirical correlations to support performance monitoring and propose maintenance strategies to mitigate degradation caused by aging and operational challenges. Pumping Power Calculator V3.0 and Rotor Zone – Pump Size were employed to simulate hydraulic shaft, and motor power, enabling an assessment of efficiency and performance curves. frictional head losses were calculated using the Darcy–Weisbach (D-W) equation, and the corresponding head loss percentage (Lƒ %) was determined. Results show that hydraulic power was limited (0.33 KW for mass flow, 0.29 KW for volumetric flow, Hƒ = 0.8 m, Lƒ = 0.2%), while mechanical efficiency remained stable at 78%, indicating effective energy transfer despite low hydraulic performance. The results highlight the significance of optimizing hydraulic pathways and implementing predictive maintenance for the sustainable pump operation of pump.
المراجع
1. Anton, A.-A., Cococeann, A., & Muntean, S. (2022). Software for monitoring the in-service efficiency
of hydraulic pumps. Journal of Applied Sciences, 12(22), 11450, 1–29.
2. Bosch Rexroth AG. (2014). Hydraulic oil supply for gas and steam turbines [Technical documentation].
https://docslib.org/doc/10670790/hydraulic-oil-supply-for-gas-and-steam-turbines
3. Badr, O., & Nguyen, T. (2021). Advanced analysis of hydraulic efficiency in centrifugal pumps under
varying flow conditions. Journal of Fluid Engineering, 143(6), 061201.
4. Bojeldain, A., Aldali, Y., & Alshaikh, M. (2022). Energy and exergy analysis of Derna steam power
plant and the impact of varying the different parameters on exergy destruction. Al-Jabal Academy
Journal of Pure and Applied Sciences, 1(1), 10–18.
5. Çengel, Y. A., & Cimbala, J. M. (2014). Fluid mechanics: Fundamentals and applications (3rd ed.).
McGraw-Hill.
6. Çengel, Y. A., & Cimbala, J. M. (2018). Fluid mechanics: Fundamentals and applications (4th ed.).
McGraw-Hill Education.
7. General Electricity Company of Libya. (2002). Derna steam power plant report.
https://gecol.ly/report2002.pdf
8. Gebremedhin, Y. M., & Tsegay, F. T. (2018). Comparative analysis and validation of selected explicit
equation models for determination of Darcy friction factor to estimate major head loss for a pressurized
flow system. Journal of Water Resource and Protection, 10(3), 345–361.
9. Jamil, R. (2019). Frictional head loss relation between Hazen-Williams and Darcy-Weisbach equations
for various water supply pipe materials. International Journal of Water, 13(4).
10. Libya Alaan. (2016, May 23). Derna and Al-Bamba power plant maintenance updates [Tweet]. Twitter.
https://twitter.com/libyaalaan.com
11. Libya Al Mostakbal. (2016, November 23). Emergency maintenance at North Benghazi Power Plant
causes expected power deficit. Libya Al Mostakbal. https://Libya-al-mostakbal.org
12. Munson, B. R., Young, D. F., Okiishi, T. H., & Huebsch, W. W. (2013). Fundamentals of fluid mechanics
(7th ed.). John Wiley & Sons.
13. Pallepati, R. R. (2014). On estimation of friction loss in pipes using Hazen-Williams and modified
Hazen-Williams formula. Journal of Indian Water Works Association (July–Sept), 107–108.
14. Shell. (2017, August 29). Shell Turbo Oil T 46 technical data sheet (Version 2.8). Shell.
15. Suryanarayana, N. V., & Nagaraju, K. (2018). Hydraulic control oil pumps in power plants: Design and
performance analysis. International Journal of Mechanical Engineering and Technology, 9(6), 1251–
1260.
16. Smith, R., & Patel, S. (2022). Mechanical losses and efficiency optimization in pump drive systems.
Mechanical Systems and Signal Processing, 165, 108213.
17. Zherdev, Y. Y., Reutov, A. A., & Avdeev, A. A. (2021). Analysis of operation of the oil-supply system
of a steam turbine before and after maintenance. IOP Conference Series: Earth and Environmental
Science, 666(5), 052021.
18. Zhang, L., & Wang, H. (2023). Comprehensive efficiency modeling of centrifugal pumps considering
hydraulic and mechanical losses. Energy Conversion and Management, 269, 116150.
